Chalkboard coat racks are a fun way to jazz up your home and to add a little character. This is a fun and simple project you can easily tackle in an afternoon. The project is made out of pine boards, some plywood, hooks, Krylon^® Chalkboard Paint in Black, and Krylon ColorMaster^®Paint + Primer in Satin Oxford Blue. I love using Krylon Chalkboard  Paint for all sorts of DIY projects. Thank you to Krylon® Brand for sponsoring this project. Click here to download the FREE chalkboard coat rack plans. 

Start by downloading the FREE Chalkboard Coat Rack Plans here. Cut the boards to length on a miter saw or circular saw. The boards are ¾ inch thick by 2 ½ inches wide. I cut the two longer boards to 39 inches and the shorter boards to 21 inches.  I cut the ½ inch thick boards that are 1 ½ inches wide to 16 inches in length. 

 If you can’t find 1x3 boards at your local store, rip a 1x4 down on a table saw. 

Here is a look at the pine boards cut down to size. 

Use a pocket hole jig to create two pocket holes at the end of each long board. Set it for ¾ inch thick stock. 

Use 1 ¼ inch long pocket hole screws to attach the boards. 

Create a ¼ inch deep by ½ inch rabbet or inset for the plywood. 

Here is what the inset will look like.

Use a circular saw to cut the ¼ inch plywood to size. It should be cut to fit in the inset. 

Use a miter saw to cut a 45 degree angle at each corner of the plywood so it will fit. 

It’s time to paint! I used 1 can of Krylon ColorMaster Paint + Primer in Satin Oxford Blue for the frame. I used 1 can of Krylon Chalkboard Paint in Black on the plywood to create the chalkboard. The coverage is great and I used 3 coats total. 

Always wear proper safety equipment while spraying paint. Make sure to be in a well-ventilated area or to use a respirator and always read the safety and application instructions on the can for additional information. The EZ touch tips on Krylon ColorMaster Paint + Primer make it so you can spray the cans upside down which makes getting the paint in all the nooks and crannies very simple.  

For Krylon ColorMaster Paint+ Primer, I waited about 10 minutes between coats. The paint dries fast which helped me create this project in no time. It sprayed on evenly without any drips or runs. 

Once the paint is dry, attach the chalkboard from the back using ½ inch nails. I used an 18 gauge nailer.   Make sure to wait the full twenty four hours before first use with chalk on the Chalkboard Paint surface.

Attach the ½ inch thick trim boards to separate the panels. Use ¾ inch long nails. 

Space the coat hangers evenly and attach using ½ inch long screws. 

Find the studs in the wall and then secure using 3-inch long wood screws.

I hope this DIY tutorial inspires you to build a chalkboard coat rack for your home and family. Please like, share, and take action if you found this post helpful! Download the FREE chalkboard coat rack plans here to get started today! Cheers from Montana. - Pete